Description
This is a simple to use intelligent battery charger with the latest PWM charging technology controlled by a powerful Micro-Processor Control Unit. It is suitable for all types of lead acid batteries from (5 to 120AH for SBC-8168) (8 to 60AH for SBC-8268).
The charger only starts charging when it is connected to a battery. So there is no spark in contact with battery terminals.
Reverse Polarity and Short Circuit protections are by electronics with flashing LED and charger will return to normal when the fault is cleared.
A total time for Bulk and Absorption charge is limited to 40 hours to avoid over charging and waste of energy. Therefore it is not suitable for application of charging battery connected to external load connected.
The charger is splash proof as its casing is sealed by ultra sonic.
It is convection cooled and has thermal regulation to lower the charging current until the unit's temperature drops to an acceptable level. In the event of persistent rising temperature the charger will shut down its output at a preset maximum temperature.
- Microprocessor Control (MCU) 4 Stage Charging (Repair, Bulk, Absorption, Float) in Pulse Width Modulation PWM method.
- MCU monitors the battery condition from initial qualifying checks, repair, or bulk to absorption to float charges.
- No worries of over or under charging battery, charger can be connected permanently to battery.
- Auto pulse repair charge for deeply depleted battery.
- Suitable for all types of Wet, Gel, AGM lead acid and Cal-Cal from 8 to 60AH.
- Thermal control regulates charging current in hot or enclosed conditions
- Two swappable leads with clamps and eyelet terminal.
- Simple 3 selection key with intuitive iconic LED indicators.
- Universal AC input 100V to 240V
The charger only starts charging when it is connected to a battery. So there is no spark in contact with battery terminals.
Reverse Polarity and Short Circuit protections are by electronics with flashing LED and charger will return to normal when the fault is cleared.
A total time for Bulk and Absorption charge is limited to 40 hours to avoid over charging and waste of energy. Therefore it is not suitable for application of charging battery connected to external load connected.
The charger is splash proof as its casing is sealed by ultra sonic.
It is convection cooled and has thermal regulation to lower the charging current until the unit's temperature drops to an acceptable level. In the event of persistent rising temperature the charger will shut down its output at a preset maximum temperature.
